Table 7.
Percent differences in the tensile specimen dimensions (with original units provided) between the annealed and as-printed conditions for each filament for both the optimal and worst-case parameter sets.
| Parameter Set | A (mm) | B (mm) | C (mm) | D (mm) | E (mm) | F (mm) | ||
|---|---|---|---|---|---|---|---|---|
| OVERTURE | White | Optimal | −4.00% | −4.15% | −4.83% | −2.40% | −5.69% | 6.57% |
| Worst-Case | −3.94% | −3.24% | −4.64% | −4.49% | 0.85% | 5.55% | ||
| Black | Optimal | −1.23% | −1.43% | −1.62% | −2.46% | −0.33% | 2.34% | |
| Worst-Case | −0.88% | −2.14% | −1.92% | −3.07% | 0.51% | 1.57% | ||
| Green | Optimal | −0.65% | −0.31% | −1.67% | −2.01% | 1.84% | 4.39% | |
| Worst-Case | −0.61% | −0.50% | −1.26% | −4.01% | 3.64% | 3.78% | ||
| SUNLU | White | Optimal | −2.29% | −2.26% | −2.52% | −1.70% | −2.67% | 1.80% |
| Worst-Case | −2.01% | −2.26% | −2.55% | −2.79% | 0.17% | 2.09% | ||
| Black | Optimal | −0.47% | −0.65% | −1.15% | −1.09% | 0.33% | 3.19% | |
| Worst-Case | −0.65% | −0.74% | −1.56% | −1.70% | 0.45% | 3.10% | ||
| Green | Optimal | −0.69% | −0.46% | −0.26% | 0.06% | −0.73% | 0.60% | |
| Worst-Case | −0.57% | −0.99% | −0.45% | −0.02% | −0.91% | 0.32% | ||
| HATCHBOX | White | Optimal | −0.51% | −0.16% | −0.60% | 0.29% | −2.29% | −1.34% |
| Worst-Case | −0.54% | −0.85% | −0.54% | −0.54% | 0.79% | 0.14% | ||
| Black | Optimal | −2.00% | −2.05% | −1.74% | −2.48% | −1.67% | 1.76% | |
| Worst-Case | −1.95% | −2.35% | −2.15% | −2.69% | −0.11% | 3.21% | ||
| Green | Optimal | −1.08% | −1.39% | −2.13% | −1.86% | −0.06% | 0.75% | |
| Worst-Case | −1.60% | −1.69% | −1.53% | −1.84% | 1.53% | 2.01% |