Skip to main content
. Author manuscript; available in PMC: 2023 May 3.
Published in final edited form as: Plast Reconstr Surg. 2022 Oct 7;151(1):72e–84e. doi: 10.1097/PRS.0000000000009798

Figure 2. Processing device design and fabrication.

Figure 2.

(A,B) Emulsification and Micronization Device (EMD) for processing LA. (A) Schematic of design and (B) picture of device produced via 3D printing. (C,D) Filtration Device (FD) for removing large tissue fragments after EMD treatment. (C) Exploded view showing six plastic layers, including two for channels (green), two acting as the filter spacer and support grid (red), and two for sealing the top and bottom of the device. The embedded nylon filter is shown in yellow. (D) Picture of the FD with 1 mm pore nylon filters that was fabricated using pressure lamination. Scale bars are 1 cm.