Figure 1.

Schematic of the microfibrous reactor fabrication

(A) Flow chart of microfibrous reactor fabrication from single layer microfibrous mat to microfibrous rod.

(B) The photograph of electrospun single-layered microfibrous mat in the area of 30 cm × 40 cm on aluminum foil.

(C) SEM image showing the morphology of the microfibrous mat surface.

(D) The white resin-made mold (length 80 mm × diameter 2.5 mm) fabricated by the 3D printer, and the cylinder-like rod PS microfibrous mat reconstructed by the mold produced (on the bottom right).

(E) The cropped white piece of “microfibrous reactor” which was later installed in a 200 μL pipette tip.