Table 12.

Assembly and integration instructions for the actuator sub-assembly. Component numbering per Tables 2–3.

Step	Instruction
1	Press the motor mount (9) onto the shutter motor (21) so that the mount sits against the flange of the motor. Insert grub screws (35) into the threaded holes, and tighten onto the motor using a 1.5  mm hex key.
2	Insert M1.6 × 16  mm socket screws (22) into the clearance holes of the mount, and place a 5.5  mm spacer (23) onto each of the screws.
3	Insert the socket screws into the clearance holes of the escapement sub-assembly. Ensure the pin of the motor arm sits inside the slot of the pallet lever arm (see detail view). The motor may need to rotated in the mount for proper alignment.
4	To integrate the actuator and escapement with the gearbox and leadscrew assemblies, insert the socket screws into the threaded holes of the gearbox housing and tighten using a 1.5  mm hex key.