Skip to main content
. 2024 Nov 13;10(46):eads2654. doi: 10.1126/sciadv.ads2654

Fig. 4. Three waveguides with one-RR configuration for signal amplification via RR.

Fig. 4.

The schematic diagram in (A) shows the simulation and the experimental setup to create the standing acoustic wave inside of the RR and waveguide by two directly opposite input signals p1 and p2. The signal will be pumping with signals p3 and p4 where a standing wave will be created by CCW and CW modes in the RR. (B) Black lines show the normalized acoustic signal inside the center RR. The transmission in ports 2 to 6 is shown in (C) to (E). (F) Simulation result shows the one input signal pin with two pumping outputs ppump with designed three waveguides with one RR, the mode in the RR is CCW mode. (G) Simulation result shows the two same input signals pin with one pumping output ppump; the mode in the RR is CCW mode. (H) Simulation result shows the two different input signals that create the CCW mode and CW mode in the RR, respectively.