Skip to main content
. Author manuscript; available in PMC: 2024 Dec 12.
Published in final edited form as: IEEE Trans Ultrason Ferroelectr Freq Control. 2024 Aug 19;71(8):960–971. doi: 10.1109/TUFFC.2024.3402530

Fig. 1:

Fig. 1:

Representative example of data obtained during an acoustic output sweep. This data corresponds to the 1.0 MI output level in a 3.8 MHz sweep. On the left, the B-mode view is seen. In the center is the noise frame. The SNR map on the far right is obtained by dividing the B-mode signal by the noise frame power. MI recommendations for imaging the fetal abdomen are based on the sector overlapping the target, shown here in red.