Skip to main content
. Author manuscript; available in PMC: 2014 Jun 3.
Published in final edited form as: IEEE Trans Biomed Eng. 2004 Oct;51(10):1726–1734. doi: 10.1109/TBME.2004.827926

Fig. 1.

Fig. 1

Coordinate system and source-sensor configuration used in the numerical experiments. The coordinate origin was set at the center of the sensor coil located at the center of the array. The plane at x = 0 cm is shown. The two point sources, shown by the small filled circles, were located on the line (x = 0; z = −6) cm. The time courses assigned to the two sources are shown in the two upper panels.