Skip to main content
. 2017 May 2;5:e3179. doi: 10.7717/peerj.3179

Table 6. Forelimb measurements of Galeamopus pabsti SMA 0011, in mm.

pdL acL min  sD max  sD min  apD ptW dtW dpcL aprL lprL papD dapD dvH scaL max  tW gl dvH  gl Comments
Scapula, R 1,375 620  (inc) 178 240  (inc) Max sD measured at distal-most preserved end
Scapula, L 1,370 620   (inc) 180 295 130 121 222 Distal end incomplete, pdL preserved straight length; max sD measured at distal-most preserved end
Coracoid, R 379 515 290 105 200
Humerus, L 870 174 70  (est) 474 309 310
Humerus, R 893 180 75 480 328 325 89 104
Radius, L 601 89 44 165 140 87 74 Min apD measured laterally
Ulna, L 628 73 78 200 123 275 177 165 95 Proximal surface deformed, ptW, papD estimated; aprL, lprL measured as preserved; papD measured from posterior-most point of radial fossa to posterior-most point of olecranon
Carpal, L 77 137 39 78 Min apD measured medially; dapd measured laterally (is equal to max apD
Mc I, L 194 62 46 79 112 75 57 Min apD, dapD measured medially; papD measured laterally
Mc II, L 232 56 44 100 103 69 63 Min sW measured dorsally; min apD, dapD measured medially
Mc III, L 242 43 41 47 85 90 48
Mc IV, L 220 44 50 60 87 110 70 dapD estimated
Mc V, L 193 46 47 76 87 114 62 Distal end reconstructed
phm I-1, L 56 66 88 50 86 77 71 71 Min sW measured at midheight; max sW measured palmarly; dapD measured medially
phm II-1, L 90 94 27 93 110 57 33 Min apD measured centrally at midshaft; dapD measured laterally
phm III-1, L
phm IV-1, L 53 21 93 45 24
phm V-1, L 39 83 49 9
Manual ungual, L 193/254 45 114 pdl measured straight/along dorsal curvature
phm II-2, L 20 42 31 Min apD = max apD

Notes.

Abb.

acL
acromion length
apD
anteroposterior depth
aprL
anterior process length
dapD
distal anteroposterior depth
dpcL
length deltopectoral crest
dtW
distal transverse width
dvH
dorsoventral height
gl
glenoid
lprL
lateral process length
papD
proximal anteroposterior depth
pdL
proximodistal length
ptW
proximal transverse width
scaL
scapula-coracoid articular length
sD
shaft diameter
sW
shaft width
tW
transverse width