Skip to main content
. 2017 May 31;7:2531. doi: 10.1038/s41598-017-02749-2

Table 3.

Intensity ratios for 4 peptide markers for 6 test development set isolates.

Isolate KPC Sample set GFLAAAVLAR LTLGSALAAPQR APIVLAVYTR LALEGLGVNGQa
ECNIH2 + A 3.47 2.16 2.89 1.35
ECNIH2 + B 3.06 1.67 2.61 1.12
ECNIH2 + C 3.09 1.69 2.52 1.13
ECNIH3 + A 1.11 0.70 1.03 0.54
ECNIH3 + B 1.24 0.65 0.99 0.49
ECNIH3 + C 1.14 0.61 0.91 0.48
E. coli A 0.03 0.00 0.02 0.11
E. coli B 0.02 0.00 0.01 0.10
E. coli C 0.02 0.00 0.02 0.11
K. pneumoniae A 0.03 0.00 0.05 0.03
K. pneumoniae B 0.03 0.00 0.05 0.03
K. pneumoniae C 0.04 0.00 0.04 0.03
KPNIH1 + A 2.62 2.31 2.80 1.81
KPNIH1 + B 2.77 1.44 2.23 1.25
KPNIH1 + C 3.26 1.64 2.54 1.29
KPNIH10 + A 3.15 2.30 2.63 1.69
KPNIH10 + B 3.06 1.84 2.75 1.38
KPNIH10 + C 2.10 1.33 1.67 1.37
Positive range 1.11–3.47 0.61–2.31 0.91–2.89 0.48–1.81
Negative range 0.02–0.04 <0.01 0.01–0.05 0.03–0.11
Lowest Pos/Neg ratio 27.8 >61.0 18.2 4.4

Intensity ratio is calculated as signal peak intensity/daily positive control intensity. Technical triplicate samples (A, B, and C) were prepared at the same time. aBased on b-ions only due to N or Q deamination; this peptide was not used in validation.