Skip to main content
. 2016 Dec 14;7(12):230. doi: 10.3390/mi7120230

Figure 2.

Figure 2

Setup of the tensile strength test. (a) Setup of the tensile tester. It has an immobile jaw at the lower position and a movable jaw connected to a force sensor at the upper position. The sample is fixed on the jaws through screws; (b) assembled sample in the tester. The sample holders were first glued with two bare glass slides. The bonded PDMS-SU-8 sample was then sandwiched between the two glass slides using silicone glue.