Table 4.

Results of wall thickness measurements depending on applied 3D printing parameters set (green line—nominal dimensions, red lines – estimated values of wall thickness).

Set Groups	W1 [mm]	W2 [mm]	W3 [mm]	W4 [mm]	S1 [mm]	S2 [mm]	S3 [mm]	S4 [mm]	H1 [mm]	H2 [mm]	H3 [mm]	H4 [mm]
Nominal Values	0.60	0.80	1.00	1.2	0.60	0.80	1.00	1.2	0.60	0.80	1.00	1.2
Set No.1	0.89 ± 0.02	1.06 ± 0.02	1.13 ± 0.03	1.32 ± 0.03	0.94 ± 0.05	1.12 ± 0.06	1.27 ± 0.04	1.48 ± 0.09	0.94 ± 0.04	1.11 ± 0.03	1.28 ± 0.03	1.50 ± 0.05
Set No.2	0.80 ± 0.02	1.01 ± 0.02	1.13 ± 0.03	1.33 ± 0.03	0.75 ± 0.04	0.94 ± 0.04	1.21 ± 0.05	1.39 ± 0.06	0.73 ± 0.05	0.93 ± 0.06	1.11 ± 0.09	1.32 ± 0.09
Set No.3	0.72 ± 0.02	0.84 ± 0.02	1.28 ± 0.03	1.36 ± 0.03	0.66 ± 0.02	0.84 ± 0.03	1.13 ± 0.03	1.31 ± 0.04	0.67 ± 0.02	0.84 ± 0.03	1.11 ± 0.03	1.38 ± 0.04