Table 5.

Normal pattern of behaviour of multi-stage thermoforming machine.

EP (Encoder Position)	0	10	100	200	300	400	450	500	600	700	800	900	970	980	990	999
AC1: Cam bottom dead centre	1	1	1	1	1	0	0	0	1	1	1	1	1	1	1	1
AC2: Drag start point	0	1	0	0	0	0	0	0	0	0	0	0	0	0	0	0
AC3: Blown Time	0	0	1	0	0	0	0	0	0	0	0	0	0	0	0	0
AC4: Start of heater operation	0	0	0	1	1	1	1	1	1	1	1	1	1	1	1	0
AC5: Dosing point	0	0	0	0	1	0	0	0	0	0	0	0	0	0	0	0
AC6: Top point cams	0	0	0	0	1	1	1	1	0	0	0	0	0	0	0	0
AC7: Home pushers	0	0	0	0	0	0	1	1	1	1	1	1	0	0	0	0
AC8: Start blowing	0	0	0	0	0	0	1	0	0	0	0	0	0	0	0	0
SA1: Humidity % inside Control Panel	60	60	60	60	60	60	60	60	60	60	60	60	60	60	60	60
SA2: Temperature inside Control Panel	40	40	40	40	40	40	40	40	40	40	40	40	40	40	40	40
SA3: Voltage supplier inside Control Panel	230	230	230	230	230	230	230	230	230	230	230	230	230	230	230	230
SA4: Pressure sensor Thermoforming step (bar)	0	0	4	0	0	0	0	0	0	0	0	0	0	0	0	0
SA5: Pressure sensor after Peristaltic Pump (bar)	0	0	0	0	0.2	0	0	0	0	0	0	0	0	0	0	0
SA6: Laser measure hp heat seal front (Data in mm)	0	0	0	0	5.0	5.0	5.0	5.0	0.0	0	0	0	0	0	0	0
SA7: Laser measure hp heat seal rear (Data in mm)	0	0	0	0	5.0	5.0	5.0	5.0	0.0	0	0	0	0	0	0	0