Skip to main content
. Author manuscript; available in PMC: 2022 Jan 7.
Published in final edited form as: Methods Cell Biol. 2019 Jun 8;152:41–67. doi: 10.1016/bs.mcb.2019.04.004

Figure 6. Mounting tape with sections on a wafer.

Figure 6.

(A) A custom-built reel holder holing a reel with tape with sections. The tape has been spread over a cutting board so that it can be cut into strips. (B) Procedure showing how a wafer is made. Left: strips of double sided carbon conductive tape are laid down along the wafer surface. Small squares for adhering fiducials are placed where appropriate. Middle: the Kapton tape with sections is cut into strips that are then placed over the adhesive carbon tape guides. Right: The orientation and order of the strips of tape should be kept consistent throughout the wafer. In this case, the order of the sections goes from top to bottom and from left to right. The wafer will be mapped in this order.