Skip to main content
. 2020 Jul 10;8:e00123. doi: 10.1016/j.ohx.2020.e00123

Fig. 14.

Fig. 14

Valve with lever replaced by a custom-made one. This lever is made from a steel striping (middle of the figure), being cut and drilled according to the necessary dimensions. Here, the existing holes on the stripping were used as a starting point, and matching holes with enough diameter (here, 3 mm) were also drilled at the servo arm (right of the figure). The rotation center of the lever and the arm must also match when assembled (Fig. 15).