Skip to main content
. 2022 May 19;9(5):218. doi: 10.3390/bioengineering9050218

Figure 13.

Figure 13

The flowchart of the GUI data acquisition from the Microcontroller: After a serial connection is set up between the GUI and the microcontroller, the user can input all the settings shown in Figure 12a. The GUI generates three commands based on the user settings and sends them to the microcontroller. Then, the serial port is checked again before establishing the measurement command on the serial port. Next, the data is received from the chip and read from the microcontroller’s SPI port buffer.