Skip to main content
. 2022 Jul 21;14(14):2955. doi: 10.3390/polym14142955

Figure 6.

Figure 6

(A) Picture of the part printed with Detax, with a designed height of 200 µm, a width of 100 µm with a separation of 300 µm. (B) Picture of the part printed with Detax, with a designed height of 200 µm, a width of 100 µm with a separation of 200 µm. (C) Picture of the part printed with Asiga, with a designed height of 200 µm, a width of 100 µm with a separation of 300 µm. (D) Picture of the part printed with Asiga, with a designed height of 200 µm, a width of 100 µm with a separation of 200 µm. (E) Picture of the part printed with Keyprint, with a designed height of 400 µm, a width of 200 µm with a separation of 600 µm. (F) Picture of the part printed with Keyprint, with a designed height of 400 µm, a width of 200 µm with a separation of 400 µm. The figures in (A,C,E) are the ones obtained with the minimum height for each resin, the width being half the weight and the separation being three times the width and with a correct definition. The figures in (B,D,F) are the ones obtained with the minimum height for each resin, the width being half the weight and the separation being two times the width, and it can be appreciated that the separation of the structures starts being imperfect. The scale bar for all figures is 200 µm.