Skip to main content
. 2026 Nov 17. Online ahead of print. doi: 10.1039/d6ra09329a

Table 7. Comparison of the advantages of reported adsorbents with the present synthesized adsorbent.

Adsorbent Maximum adsorption capacity Qmax (mg g−1) Reported conditions Key features or limitations Reference
Jatropha oil-cake biochar nanobiomaterial 24.3 pH 4; 90 min Low-cost biomass-derived material; dye recovery of up to 96.3% with acetone was reported 62
Water hyacinth leaves 170.8 pH 1.5–2.0 Renewable biosorbent; acidic conditions were required 63
Mesoporous silica (MCM-41) 172.4 90 min Ordered mesoporous structure; pseudo-second-order kinetic fit was reported 64
Chemically mediated manganese ferrite 271.89 100 min; pH 5 Magnetic ferrite material 65
Green-synthesized manganese ferrite 391.34 90 min; pH 4 Higher reported capacity than chemically mediated manganese ferrite in the same report 66
Pilot-scale super-activated carbon 537 pH 3; 303 K Very high reported capacity; pilot-scale production was demonstrated, but desorption/regeneration is needed 67
TM-CuNiZn–BDC MOF (present study) 689 pH 6; 333 K; 60 min Trimetallic MOF; BET surface area 654 m 2 g −1 ; removal efficiency above 93% under the reported optimum conditions Present study