Skip to main content
AAPS PharmSciTech logoLink to AAPS PharmSciTech
. 2004 May 11;5(3):16–22. doi: 10.1208/pt050338

Effect of starting material particle size on its agglomeration behavior in high shear wet granulation

Sherif I Farag Badawy 1,, Munir A Hussain 1
PMCID: PMC2750261  PMID: 15760071

Abstract

The effect of anhydrous lactose particle size distribution on its performance in the wet granulation process was evaluated. Three grades of anhydrous lactose were used in the study: “as is” manufacturer grade and 2 particle size fractions obtained by screening of the 60M lactose. Particle growth behavior of the 3 lactose grades was evaluated in a high shear mixer. Compactibility and porosity of the resulting granules were also evaluated. A uniaxial compression test on moist agglomerates of the 3 lactose grades was performed in an attempt to explain the mechanism of particle size effect observed in the high shear mixer. Particle growth of anhydrous lactose in the high shear mixer was inversely related to the particle size of the starting material. In addition, granulation manufactured using the grade with the smallest particle size was more porous and demonstrated enhanced compactibility compared with the other grades. Compacts with similar porosity and low liquid saturation demonstrated brittle behavior and their breakage strength was inversely related to lactose particle size in the uniaxial compression test, suggesting that material with smaller particle size may exhibit more pronounced nucleation behavior during wet granulation. On the other hand, compacts prepared at higher liquid saturation and similar compression force exhibited more plastic behavior and showed lower yield stress for the grade with smallest particle size. The lower yield stress of compacts prepared with this grade may indicate a higher coalescence tendency for its granules during wet granulation.

Keywords: anhydrous lactose, particle size, high shear, wet granulation, granule growth

Full Text

The Full Text of this article is available as a PDF (200.9 KB).

References

  • 1.Kristensen HG. Agglomeration of powders. Acta Pharm Suec. 1988;25:187–204. [Google Scholar]
  • 2.Tardos IG, Khan MI, Mort PR. Critical parameters and limiting conditions in binder granulation of fine powders. Powder Technol. 1997;94:245–258. doi: 10.1016/S0032-5910(97)03321-4. [DOI] [Google Scholar]
  • 3.Ouchiyama N, Tanaka T. The probability of coalescence in granulation kinetics. Ind Eng Chem Process Des Dev. 1975;14:286–289. doi: 10.1021/i260055a016. [DOI] [Google Scholar]
  • 4.Iveson SM, Beathe JA, Page NW. The dynamic strength of partially saturated powder compacts: the effect of liquid properties. Powder Technol. 2002;127:149–161. doi: 10.1016/S0032-5910(02)00118-3. [DOI] [Google Scholar]
  • 5.Liu LX, Lister JD, Iveson SM, Ennis BJ. Coalescence of deformable granules in wet granulation processes. AIChE J. 2000;46:529–539. doi: 10.1002/aic.690460312. [DOI] [Google Scholar]
  • 6.Iveson SM, Lister JD, Hapgood H K, Ennis BJ. Nucleation, growth and breakage phenomenon in agitated wet granulation process: a review. Powder Technol. 2001;117:3–39. doi: 10.1016/S0032-5910(01)00313-8. [DOI] [Google Scholar]
  • 7.Holm P, Schaefer T, Kristensen HG. Granulation in high-speed mixers. Part V. Power consumption and temperature changes during granulation. Powder Technol. 1985;43:213–223. doi: 10.1016/0032-5910(85)80002-4. [DOI] [Google Scholar]
  • 8.Kristensen HG, Holm P, Schaefer T. Mechanical properties of moist agglomerates in relation to granulation mechanisms. Part I. Deformability of moist, densified agglomerates. Powder Technol. 1985;44:227–237. doi: 10.1016/0032-5910(85)85004-X. [DOI] [Google Scholar]
  • 9.Kristensen HG, Holm P, Schaefer T. Mechanical properties of moist agglomerates in relation to granulation mechanisms. Part II. Effect of particle size distribution. Powder Technol. 1985;44:239–247. doi: 10.1016/0032-5910(85)85005-1. [DOI] [Google Scholar]
  • 10.Badawy SIF, Lee TJ, Menning MM. Effect of drug substance particle size on the characteristics of granulation manufactured in a high shear mixer. AAPS PharmSciTech. 2000;1(4):E33–E33. doi: 10.1208/pt010433. [DOI] [PMC free article] [PubMed] [Google Scholar]
  • 11.Badawy SIF, Menning MM, Gorko MA, Gilbert DL. Effect of process parameters on compressibility of granulation manufactured in a high shear mixer. Int J Pharm. 2000;198:51–56. doi: 10.1016/S0378-5173(99)00445-7. [DOI] [PubMed] [Google Scholar]
  • 12.Wikberg M, Alderborn G. Compression characteristics of granulated materials. IV. The effect of granule porosity on the fragmentation propensity and compactibility of some granulations. Int J Pharm. 1991;69:239–253. doi: 10.1016/0378-5173(91)90366-V. [DOI] [Google Scholar]
  • 13.Kibbe AH. Handbook of Pharmaceutical Excipients. Washington, DC: American Pharmaceutical Association; 2000. Lactose; pp. 278–278. [Google Scholar]

Articles from AAPS PharmSciTech are provided here courtesy of American Association of Pharmaceutical Scientists

RESOURCES