Abstract
This study aims to investigate the effect of the ice nucleation temperature on the primary drying process using an ice fog technique for temperature-controlled nucleation. In order to facilitate scale up of the freeze-drying process, this research seeks to find a correlation of the product resistance and the degree of supercooling with the specific surface area of the product. Freeze-drying experiments were performed using 5% wt/vol solutions of sucrose, dextran, hydroxyethyl starch (HES), and mannitol. Temperature-controlled nucleation was achieved using the ice fog technique where cold nitrogen gas was introduced into the chamber to form an “ice fog”, there-by facilitating nucleation of samples at the temperature of interest. Manometric temperature measurement (MTM) was used during primary drying to evaluate the product resistance as a function of cake thickness. Specific surface areas (SSA) of the freeze-dried cakes were determined. The ice fog technique was refined to successfully control the ice nucleation temperature of solutions within 1°C. A significant increase in product resistance was produced by a decrease in nucleation temperature. The SSA was found to increase with decreasing nucleation temperature, and the product resistance increased with increasing SSA. The ice fog technique can be refined into a viable method for nucleation temperature control. The SSA of the product correlates well with the degree of supercooling and with the resistance of the product to mass transfer (ie, flow of water vapor through the dry layer). Using this correlation and SSA measurements, one could predict scaleup drying differences and accordingly alter the freeze-drying process so as to bring about equivalence of product temperature history during lyophilization.
Keywords: nucleation, freeze-drying, scale-up, mass transfer
Full Text
The Full Text of this article is available as a PDF (213.1 KB).
References
- 1.Pikal MJ, Rambhatla S, Ramot R. The impact of the freezing stage in lyophilization: effects of the ice nucleation temperature on process design and product quality. American Pharmaceutical Review. 2002;5:48–52. [Google Scholar]
- 2.Pikal MJ. Freeze drying. In: Swarbrick J, Boylan J, editors. Encyclopedia of Pharmaceutical Technology. New York: Marcel Dekker; 2001. [Google Scholar]
- 3.Searles JA, Carpenter JF, Randolph TW. Annealing to optimize the primary drying rate, reduce freezing-induced drying rate heterogeneity, and determine T-g' in pharmaceutical lyophilization. J Pharm Sci. 2001;90:872–887. doi: 10.1002/jps.1040. [DOI] [PubMed] [Google Scholar]
- 4.Searles JA, Carpenter JF, Randolph TW. The ice nucleation temperature determines the primary drying rate of lyophilization for samples frozen on a temperature-controlled shelf. J Pharm Sci. 2001;90:860–871. doi: 10.1002/jps.1039. [DOI] [PubMed] [Google Scholar]
- 5.Kochs M, Korber C, Nunner B, Heschel I. The influence of the freezing process on vapor transport during sublimation in vacuumfreeze-drying. Int J of Heat and Mass Transfer. 1991;34:2395–2408. doi: 10.1016/0017-9310(91)90064-L. [DOI] [Google Scholar]
- 6.Roy ML, Pikal MJ. Process control in freeze drying: determination of the end point of sublimation drying by an electronic moisture sensor. J Parenter Sci Technol. 1989;43:60–66. [PubMed] [Google Scholar]
- 7.Rowe TD. A technique for the nucleation of ice. Paper presented at: International Symposium on Biological Product Freeze-Drying and Formulation; October 26, 1990; Geneva, Switzerland.
- 8.Rambhatla S, Pikal MJ. Heat and mass transfer scale up issues during freeze-drying. Part I. Atypical radiation and the edge-vial effect. AAPS PharmSciTech. 2003;4:E14–E14. doi: 10.1208/pt040214. [DOI] [PMC free article] [PubMed] [Google Scholar]
- 9.Milton N, Pikal MJ, Roy ML, Nail SL. Evaluation of manometric temperature measurement as a method of monitoring product temperature during lyophilization. PDA J Pharm Sci Technol. 1997;51:7–16. [PubMed] [Google Scholar]
- 10.Pikal MJ, Roy ML, Shah S. Mass and heat transfer in vial freeze-drying of pharmaceuticals: role of the vial. J Pharm Sci. 1984;73:1224–1237. doi: 10.1002/jps.2600730910. [DOI] [PubMed] [Google Scholar]
- 11.Adenyika WN, Thomas D. Vial breakage by frozen mannitol solutions: correlation with thermal characteristics and effect of stereoisomerism, additives, and vial configuration. J Parenter Sci Technol. 1991;45:94–100. [PubMed] [Google Scholar]
- 12.Pikal MJ. Heat and mass transfer in low pressure gases: applications to freeze drying. In: Amidon G, Lee P, Topp L, editors. Transport Process in Pharmaceutical Systems. New York: Marcel Dekker; 1999. [Google Scholar]
- 13.Pikal MJ. Use of laboratory data in freeze drying process design: heat and mass transfer coefficients and the computer simulation of freeze drying. J Parenter Sci Technol. 1985;39:115–139. [PubMed] [Google Scholar]