A figure in the article by Huyke et al. [(2021), J. Synchrotron Rad. 28, 1100–1113] is corrected.
Keywords: microfluidics, mixing, X-ray spectroscopy, kinetics, 3D microfabrication
Abstract
A figure in the article by Huyke et al. [(2021), J. Synchrotron Rad. 28, 1100–1113] is corrected.
The length of the chip was labeled incorrectly in Fig. 9 of the original publication ▸. Specifically, the 12.8 mm dimension applies for the entire length of the chip. For convenience, we also show here the locations of the three inlet ports (these were shown correctly in the original CAD-file of the supporting information). Note that this correction does not influence the discussions or conclusions. The correct figure is shown below. ▸
Figure 9.
CAD-renderings of microfluidic mixer. (a) Isometric view of fused silica chip-polyimide capillary subassembly with key dimensions labeled. The three inlets to the chip are labeled. (b) Cross-sectional view at the location of the dashed line in (a). The three channels inside of the fused silica chip are highlighted for clarity.
References
- Huyke, D. A., Ramachandran, A., Ramirez-Neri, O., Guerrero-Cruz, J. A., Gee, L. B., Braun, A., Sokaras, D., Garcia-Estrada, B., Solomon, E. I., Hedman, B., Delgado-Jaime, M. U., DePonte, D. P., Kroll, T. & Santiago, J. G. (2021). J. Synchrotron Rad. 28, 1100–1113. [DOI] [PMC free article] [PubMed]